产品在运输到现场后就位时，若采用牵引孔使本体就位，拉动速度要小于0.1

产品在运输到现场后就位时，若采用牵引孔使本体就位，拉动速度要小于0.1km/h,若要起吊主体时,起吊尺寸参考外型图，吊绳夹角小于30,必须同时采用四只吊板起吊，吊绳承重至少大于总重2倍以上，若采用液压推进就位，液压装置不能直接顶在变压器本体上，千斤顶必须四只同时使用，每只千斤顶承重不得少于总重的1/2。

結果 (英文) 1:

Products in transport to the site after a bit, the use of traction hole body in place, pull the speed is less than 0.1km / h To lifting body lifting size reference appearance Figure sling angle of less than 30  must use four hanging plate lifting sling bearing at least greater than the total weight of more than two times, the use of hydraulic propulsion in place, hydraulic device can not be directly on top of the transformer body, four jacks must be used simultaneously, each jack bearing not less than 1/2 of the weight of the total.

結果 (英文) 2:

Products in the transportation to the scene in place, if the traction hole so that the body is in place, pulling speed is less than 0.1km/h, if the lifting body, lifting size reference outline drawing, the rope angle is less than 30, must also uses four hanging plate lifting sling load weight, at least more than more than 2 times, if the use of hydraulic propulsion. The hydraulic device, not directly on the top of the transformer body, Jack must four use at the same time, each jack load shall not be less than 1/2 of total weight.

結果 (英文) 3:

Products in transport to scene Hou seated Shi, if used traction hole makes ontology seated, pulling speed to is less than 0.1km/h, to lifting main Shi, lifting size reference outside type figure, hanging rope angle is less than 30 , must while used four only hanging plate lifting, hanging rope bearing at least is greater than total heavy twice times above, if used hydraulic advance seated, hydraulic device cannot directly top in transformer ontology Shang, Jack must four only while using, each only Jack bearing shall not be less than total heavy of one-second.