电池组放电后，应立即转入充电，开始时可控制电流不大于0.2C（A）为宜

电池组放电后，应立即转入充电，开始时可控制电流不大于0.2C（A）为宜（如200Ah电池，充电电流应不大于0.2×200=40A）。当电流变小时，可慢慢提高电池组充电电压，达到均充电压值，再充6小时，然后再调回浮充电压值。

結果 (英文) 1:

After the battery discharge, should be immediately transferred to the charge, the current can be controlled at the start of no more than 0.2c (a) is appropriate (eg 200ah battery, the charging current should be less than 0.2 × 200 = 40a). When the current decreases, can slowly increase the voltage of the battery pack, charging pressure values ​​were reached, and then charge 6 hours, and then transferred back to the float voltage value.

結果 (英文) 2:

battery discharge, should be immediately transferred to start charging, can control the current less than 0.2C (A) is appropriate (such as 200Ah battery, charging current should be less than 0.2 * 200=40A). When the current change hours, slowly increase the battery charging voltage, charging voltage value to, and then charge 6 hours, and then back to the value of the floating voltage.

結果 (英文) 3:

After battery discharge, should be immediately transferred to the charge current can be controlled at the beginning is not more than 0.2C (a) is appropriate (such as a 200Ah battery, the charging current should be less than 0.2x200=40A). When the current is smaller, can slowly increase battery voltage, charge voltage value is reached, replenishment for 6 hours, then back to float charging voltage.