本工程标志设计以确保交通畅通和行车安全为目的，通过交通标志的引导，顺利

本工程标志设计以确保交通畅通和行车安全为目的，通过交通标志的引导，顺利、快捷地抵达目的地为原则。
(1)交通标志分为主标志和辅助标志两大类。
①警告标志：警告驾驶员及行人注意前方影响行车安全危险地点的标志。采用边长90cm，颜色为黄底、黑边、黑图案、形状为顶角朝上的等边三角形。
②禁令标志：禁止或限制车辆、行人交通行为的标志。采用颜色为白底、红圈、红杠、黑图案、直径为80cm的圆形。如禁止停放，限速60km/h，禁止鸣喇叭等。
③指示标志：指示车辆和行人行进的标志。
④指路标志：传递道路方向、到达地点、距离等信息的标志。大小视情况而定，颜色为蓝底白图案，指路牌字高50cm。
⑤辅助标志附设在主标志下面，不能单独使用。辅助标志对主标志补充说明车辆种类、时间起止、区间范围或距离和警告、禁令的理由等。
(2)交通标志设置原则如下：
①交通标志应设置在驾驶人员和行人容易看到，并能准确判读的醒目位置。根据需要可设置照明或采用反光、发光标志。
②各种标志一般设置在车辆行进方向道路右侧或分隔带上。标志牌不得侵入道路建筑限界，牌面下缘至地面高度为1.8～2.5m。
③路侧式标志应减少标志板面对驾驶员的眩光。板面应与道路中线垂直或成一定角度。指路或警告标志为0°～10°，禁令或指示标志为0°～15°。
④同一地点需设两种以上标志时，可合并安装在一根标志柱上，但最多不应超过四种，标志内容不应矛盾、重复。让路标志、解除限速标志、解除禁止超车标志等应单独设置。
(3)各种标志的设置地点如下：
①警告标志应分别设置在进入平面交叉之前，急弯、陡坡、反向曲线起终点、傍山险路、窄桥、窄路、铁路道口、路面滑溜、隧道、交通事故多发路段等危险地点前。
②禁令标志应分别设置在限制车速、限制轴线、限制高度、限制宽度、禁止鸣笛、禁止停车、禁止左转弯、禁止右转弯、禁止掉头、禁止超车、禁止某车辆或一切车辆通行等处。
③指标标志设置在交叉口进口道前以指示车辆行驶方向、车道类别，以及人行横道，准许试刹车、准许掉头等路段上。
④指路标志应设置在距平面交叉30～80m处，指明方向、到达地点、距离。互通式立体交叉指路标志设置在立体交叉前适当位置。路名牌设置在交叉口各面及两个交叉口间距离较长的路段之间。
(4)交通标志支撑方式有单柱式、双柱式、悬臂式、门式与附着式。
有下列情况之一者，可以用悬臂式或门式：
①视距受限，无适当地点设置地面标志。
②单方向多车道的干路。
③复杂的立体交叉。
(5)按夜间反光要求设计，标志牌底色采用三级反光膜。交通标志形状、规格、图案和颜色应符合

結果 (英文) 1:

Logo design of the project to ensure smooth transport and traffic safety for the purpose of boot by traffic signs, smoothly and quickly reach the destination principle.(1) traffic signs-signs and auxiliary signs two major categories.① warning signs: warning drivers and pedestrians in front of flags that influence road safety hazard. Using 90cm on a side, the color is Huang Di, black trim, black pattern, shape corners of equilateral triangles.II prohibition sign: prohibiting or restricting vehicular and pedestrian traffic signs. By color, red circle on a white background, red bar, black, pattern, diameter 80cm circle. Such as the prohibition of parking, speed limit is 60km/h, No Honking horns.③ signs: road signs to direct traffic and pedestrians.④ Guide sign: pass on the road sign of direction, place of arrival, distance and other information. Size as the case may be, the color is a blue-and-white patterns, signpost high 50cm.⑤ guides are attached under the main logo, cannot be used alone. Guides supplement the primary flag indicating the type of vehicles, start, range or distance and warning, and grounds for the ban.(2) traffic signs set are as follows:① traffic signs should be set up in easy to see drivers and pedestrians, and striking location accurately. Lighting can be set as required or reflective, luminous signs.② signs generally set in vehicles heading way right or on a reserve. Signs may not invade the boundary line of road construction, faces lower margins to ground height is 1.8~2.5M.③ road-side sign signs face drivers glare should be reduced. Panels should be vertically or at an angle to the road centerline. Directions or warning signs for 0 ° ~10 °, prohibition or instruction symbols for 0 ° ~15 °.④ in the same location when you need two or more signs, to merge mounted on a flag pole, but shall not exceed a maximum of four marks should not conflict, duplicated content. Give way signs, lifting the speed limit signs, lifting the prohibition of overtaking flag should be set.(3) the location of various flags are as follows:① warning signs should be set before entering the crossing, sharp bends, steep slope, reverse curve end, near the steep precipice mountain road, narrow bridges, narrow roads, railway crossings, road slipperiness, tunnel, traffic accident-prone road sections before the dangerous sites.II ban flag should be set on speed limits, restricted axis, height restrictions, limits width, honking, no parking, prohibited left turn, no right turn, no u-turn, prohibit overtaking, ban certain types of vehicles or vehicle traffic.③ indicator flag is set in front of the intersection approaches to indicate direction of vehicle travel, lane categories, and crosswalks, allowing test on roads such as the brakes, allowing to turn.About road signs should be set up away from the grade crossing at 30~80m, direction, location, distance of arrival. Interchange direction flag is set in front of the interchange where appropriate. Lu install at intersections and the long distance between the two intersections between the sections.(4) traffic signs supported single column, double column, cantilever, portal and attached.Any of the following circumstances, you can use cantilever crane or gantry: ① Visual range is limited, no suitable locations for setting land marks. ② one-way multi-lane roads. ③ complex interchanges.(5) press night reflective design, color of the sign by third grade. Traffic sign shape, size, pattern, and color should be consistent with

結果 (英文) 3:

The project logo design to ensure the traffic flow and traffic safety for the purpose, through the guidance of the traffic signs, smooth and fast to reach the destination for the principle of.(1) traffic signs are divided into two major categories: the main signs and the auxiliary signs.Warning signs: warning drivers and pedestrians to pay attention to the signs of dangerous locations in front of the traffic safety. The length of 90cm, the color is yellow, black, black pattern, shape for the upward angle of an equilateral triangle.Prohibition sign: prohibition or restriction of vehicle and pedestrian traffic sign. The use of color is white, red circle, red bars, black patterns, the diameter of the circular 80cm. Such as the prohibition of parking, the speed limit 60km/h, no sound horn, etc..Indicator: indicator for vehicles and pedestrians.The sign sign: pass on the road direction, location, distance and other information. Size depending on the situation, the color is blue and white pattern, the road sign high 50cm.The auxiliary sign attached below the main sign, can not be used alone. Supplementary signs to the main signs supplementary description of the vehicle type, time starting and ending, range or distance and warning, the reasons for the ban, etc..(2) the principle of traffic sign setting is as follows:Traffic signs should be set up in the driver and pedestrians are easy to see, and can accurately interpret the eye-catching location. According to the need to set the lighting or the use of reflective, luminous signs.A variety of signs are generally set in the direction of the road or the road on the right side of the road. The sign shall not invade road clearance, edge to the ground height of 1.8 ~ 2.5m under the surface of the card.The roadside signs should reduce glare on the driver's sign board. The board should be with the road centerline vertical or in a certain angle. The guide or warning sign is 0 degrees to 10 degrees, the ban or indication is 0 degrees to 15 degrees.The same place need to set up more than two kinds of signs, with mounted on a flag pole, but shall not exceed a maximum of four marks, the content should not repeat, contradiction. Give way signs, lift the speed limit signs, lifting the ban should be set to separate signs and other signs.(3) the settings of the various signs are as follows:The warning signs shall be set up before entering the intersection, bends and steep slopes, near the mountain, from the end of reverse curve road, narrow bridge, narrow road, railway crossing, slippery road, tunnel, traffic accident prone sections before the dangerous place.The ban signs should be set separately in the speed limit, limit, limit, limit the height axis width, honking, no parking, no left turn, right turn prohibition, no U-turn, no overtaking, banned a vehicle or all vehicles etc..The sign of import front to indicate the direction of travel of the vehicle, lane at the intersection of categories, and to test the crosswalk, brake, turn on the road to.The sign should be set at a distance of 30 ~ 80m at the intersection, direction, location, distance. The interchange type of three dimensional cross guide sign is set to the proper position before the intersection. The road name brand is arranged between each face of the intersection and the long distance between the two intersections.(4) the traffic signs are supporting single column and double column type, cantilever, door type and attachment type.One of the following circumstances, can use the cantilever gate:The sight distance is limited, and the ground sign is not set up properly.The single direction of multi Lane roads.Complex three-dimensional intersection.(5) according to the design requirements the sign color reflective at night, using three grade reflective film. The shape, size, pattern and color of traffic sign should be in accordance with the