【I/O监控】指示输入点Xn，输出点Yn的信号（n=1,2,3…..）

【I/O监控】指示输入点Xn，输出点Yn的信号（n=1,2,3…..）与PLC面板指示对应。
3,、参数设定
【电压下限】【电压上限】设定电池的测试电压最小值，最大值
【内阻下限】【内阻上限】设定电池的测试内阻最小值，最大值
【电压补偿】次设定为消除测试线路对电池电压值的影响，默认为0
【内阻补偿】次设定为消除测试线路对电池内阻值的影响，默认为0

結果 (英文) 1:

"I/O monitor" indicates that the input point Xn, Yn signal output (n=1,2,3. ....) corresponding to the PLC Panel indicate.3, and parameter setting"Voltage lower limit" "voltage limit" setting battery test voltage minimum, maximum"The resistance limit" "resistance ceiling" set the test internal resistance minimum, maximum"Compensation" is set to eliminate the influence of test circuit for the battery voltage value, the default is 0"Compensation of internal resistance" set to eliminate the influence of test circuit for battery internal resistance values, default 0

結果 (英文) 3:

[I/O monitor] indicate the input point of Xn, the output point of the signal (n=1,2,3 Yn... PLC panel indicator.3, parameter setting[voltage] [voltage] [voltage limit] set the minimum battery voltage test, the maximum value[] [] resistance limit resistance limit set battery internal resistance measurement of the minimum value, maximum valueVoltage compensation is set to eliminate the impact of test lines on the battery voltage, the default is 0[time] resistance compensation set for the elimination of test line impact on the battery internal resistance, the default is 0