放电是为了检查电池容量是否正常，一般采用10小时率放电，有条件的可用假

放电是为了检查电池容量是否正常，一般采用10小时率放电，有条件的可用假负载放电；从用户方便考虑，也可直接用负载进行放电，即拉掉市电，用电池组供电，考虑到安全性，放电深度控制在30～50％为宜。当然，有条件可放电更深一些，容易暴露电池潜在的问题。并且每小时检测一次单体电池电压，通过计算放出电池容量，对照表3电压值，判断电池是否正常

結果 (英文) 1:

Discharge is to check the battery capacity is normal, generally 10-hour rate discharge, conditional discharge dummy load is available; convenient to consider from the user, can also be directly used to discharge the load, ie pull out the mains, battery-powered, taking into account security, control of the depth of discharge is preferably 30 to 50%. Of course, conditions can be discharged deeper, the battery is likely to expose potential problems. Hourly and the cell voltage detection, the battery capacity is discharged by calculating the control voltage values ​​in Table 3, it is determined whether the battery is normal

結果 (英文) 2:

In order to check the battery discharge capacity is normal, generally use the 10 hour rate discharge, conditional dummy load discharge; consider the convenience from the user, also can be directly used load to discharge, namely pull off electric, battery powered, considering the security, depth of discharge control in 30 ~ 50%. Of course, the conditions can be discharge deeper, easy to expose the problem of battery potential. And each hour detecting a single battery voltage, battery capacity by calculating the release, table 3 voltage value, judges whether the battery is normal

結果 (英文) 3:

Normal discharge is to check the battery capacity, the General 10 hour rate discharge, conditional load discharge; considered from the user, can also directly load discharge, that is, pull out mains, battery-powered, security considerations, depth of discharge control in 30~50%. Of course, a conditional discharge much deeper, exposed battery potential problem. And testing a single battery voltage per hour, by calculating the release battery control table 3 voltage value, tell if the battery is normal