【电池电压】【电池内阻】当前测试电池的实时电压值和内阻值。【系统可以正

【电池电压】【电池内阻】当前测试电池的实时电压值和内阻值。
【系统可以正常运行！】故障报警和运行指示区。
【报警清除】故障发生后，按报警提示来处理，清除故障后按【报警清除】即可。

5、I/O监控


说明：指示灯为红色时则无信号输入或输出，指示灯为蓝色时则有信号输入或输出。
Y0，Y1为波轮步进电机的输入信号，此信号为高速信号无法采集，请观察PLC上Y0和Y1输出指示灯，有规律的闪烁则一般信号输出正常。

結果 (英文) 1:

"Battery voltage" and "internal resistance" current tests the real-time voltage and internal resistance values."The system works! "Fault alarm and operating instructions section."Alarm cleared" after the fault occurred, according to alarm, clear the fault press "alarm cleared".5, I/O monitorNote: when the light is red there is no signal input or output, light is blue when the signal input or output. Y0,Y1 wave gear stepping motor input signal, this signal for high-speed signal cannot be collected, please observe the Y0 and Y1 on the PLC output light, regular flashing signal output is normal.

結果 (英文) 3:

[] [] the internal resistance of the battery cell voltage current test battery voltage value and internal resistance.The system can run normally! Fault alarm and operation indication area.After the fault occurs, according to the warning prompt to deal with, after clearing the fault according to the alarm clearance can be.5, I/O monitoringExplanation: when the indicator light is red, there is no signal input or output, when the indicator light is blue, there is a signal input or output.Y0, Y1 is the impeller step into the motor of the input signal, the signal for the high-speed signal can not be collected, please observe the PLC Y0 and Y1 output indicator, a regular blinking signal output.